What’s Included:- (1) Micro USB control board. (2) Piezo misting disc. (3) White foam pipe (wick) . Maintenance:- 1. Always soak the wick before using. 2. Refill the water before it runs out. 3. Store the board in a dry, clean place after use.
Power Connection:-(1) Use a 5V, 1A or 2A mobile charger. (2) Plug into the micro USB port on the board. (3) Do not use more than 5V – it may damage the circuit.
Water & Wick Setup:-(1) Place the mist disc so the metal side is just 1–2 mm under water. (2) Do not submerge the black plastic part with wires. (3) Soak the white foam wick in water before first use:-(a) If dry, misting will be delayed. (b) If wet, mist willstart almost instantly.
Switch Modes:- 1st Press:- Continuous mist. 2nd Press:- Intermittent mist (on/off pattern). 3rd Press:- May turn off the device (if available on the board).
Precautions:- 1. Never turn it on without water – it will damage the mist disc. 2. Use filtered or distilled water for longer life. 3. If mist output reduces, gently clean the disc surface. 3. Replace the mist disc every 500–1000 hours of use
